Purchased equipment: the means used to minimize the possibility of oil contaminating the boiler feed
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

the means used to minimize the possibility of oil contaminating the boiler feed
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Boilers Flashcards | Quizl

what must be done to the tube to prevent an increase in pressure and the possibility of blowing the plug out of the tube after plugging if a boiler tube cannot be removed immediately because of its location in the boiler and a decision is made to plug the tube?

48 questions in Chemical Recycling of Plastic Waste

The purpose of this question is to bring researchers together to discuss and network the issue of plastic waste in the sea. Both large waste items and plastic particle waste the likes ingested by

Operation and Maintenance Guide

WATER TREATMENT Properly treated boiler feed water, coupled with good engineering and operating practices, lead to maximum effectiveness and long trouble-free life of

N-Nitrosomorpholine | C4H8N2O2 - PubCh

N-Nitrosomorpholine is a yellow, crystalline nitrosamine that is sensitive to light. N-Nitrosomorpholine is not used or produced commercially in the US. This substance has been found as a contaminant in rubber products, including rubber nipples for baby bottles, and is also found in several vegetables, cheeses, alcoholic beverages and fruits.

8: - Sean's Technology Blog - CS

<?php // Plug-in 8: Spell Check // This is an executable example with additional code supplied // To obtain just the plug-ins please click on the Download link

Environmental Regulations and Technology: Managing Use

Any oil that has been refined from crude oil, or any synthetic oil, that has been used and as a result of such use is contaminated by physical or chemical impurities. For the purpose of this document, however, 'the term "used oil" means motor oil that has been removed from the crankcase of an automobile or truck (unless otherwise indicated).

Recommended International Code of Hygienic Practice fo

cooling or air-sweeping of the product. Where necessary, precautions should be taken to remove oil, moisture If twin feed-balance tanks have to be used these be

Water Pollution | Springer for Research & Developme

A complex nitrogenous fertilizer plant based on the production of ammonium nitrate and urea products may give rise to pollutants such as ammonium nitrate, nitric acid, ammonia, urea, sulfuric acid, caustic soda, chromate, oil, grease and boiler feed additives, contained within the overall effluent stream.

Water Specialists for the Petrochemical Sect

of the steam and the quality of the water used as boiler-feed is of paramount importance to operating efficiency. The minutest contamination by sodium and silica can lead to problems over time. Ovivo’s responsibility to its clients is to minimize any disruption. We can evaluate the best technical solutions at installation or recommend process

CHAPTER APPARATUS AND EXPERIMENTAL TECHNIQUES USED IN TH

to the atmosphere by the backing pump. The oil vapour impinging on the water cooled pump wall condenses and drains to the boiler where it is re-evaporated. In order to minimize the emission of contaminating vapours, oil should be stable in regard to the thermal

How to use minimize in a sentence - WordHip

Surrounding the boiler are layers of insulation or lagging to minimize heat loss to the surroundings. High Fidelity is an attempt to minimize the effect of the electro-mechanical means necessary to the reproduction of music.

text