Purchased equipment: power plant boiler control
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

power plant boiler control
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

PLC & SCADA Based Effective Boiler Automation System fo

alarm. Boiler automation ladder diagram is designed using WPL soft and SCADA design is done by Intouch wonderware. Index Terms— Communication cables, Programmable Logic Controller (PLC), Power Plant, Supervisory Control and Data Acquisition system (SCADA). I. INTRODUCTION Over the years the demand for high quality, greater efficiency

Global Standard Power Plant Monitoring and Control Syst

Global Standard Power Plant Monitoring and Control System 196 displays and a multi-monitor configuration whereby two monitors can be connected to each HMI CPU (central processing unit) (see Fig. 5). As ease-of-use for monitoring and operation is an essential requirement for achieving efficient plant

Power Plant Control ppt | Boiler | Power Stati

Distributed Control Systems Boiler controls, including the combustion (firing rate) furnace draft, steam temperature and feed-water control loops. Burner control and pulverizer control Control loops in the plant auxiliary systems that need to be monitored and/or operated the main control room. Data acquisition and reporting functions

The Application of Switching Control to Boiler-Turbin

The marine steam power plant boiler- turbine coordinated control strategy is to solve the contradiction between the mobility and safety, which is caused by the host load changes quickly and boiler energy supply changes slowly.

Boiler Maintenance – Joul

We are specialist boiler designers, constructors and problem solvers, having built and designed boilers for some of the largest boiler companies in the world including B&W, N.E.I and ICAL. Many of the problems inherent to a boiler plant are often caused by errors of judgement and short cuts taken in the original design of the boiler.

Future power plant control - Integrating - ABB L

Future power plant control - Integrating process & substation Session Electrical Systems automation into one system abb id 92 track 7 electrical systems v02.doc Page 4 of 23 be utilized for cost efficient operation and maintenance. As one consequence, serial interfaces

Turbine, Generator, Boiler & Control System Training | G

Power Services Training is your key to turning knowledge into power by providing high-quality training that will help you maximize the efficiency of your equipment, minimize the costly mistakes that can jeopardize your plant, and build life-long skills.

Sliding Mode Predictive Control of Main Steam Pressure i

: coal fired power plant boiler combustion system main steam pressure sliding mode control Smith predictor internal model control

BOILER-TURBINE DYNAMICS IN POWER-PLAN

BOILER-TURBINE DYNAMICS IN POWER-PLANT CONTROL___ |0|0 | BOILER-TURBINE DYNAMICS

A New Era in Power Plant Control Performance - Ener

A New Era in Power Plant Control Performance By Bernd Lamb, Klaus Wendelberger and Bernhard Meerbeck In many countries, plants have to ful¿ ll speci ¿ c requirements of the electrical grid (such as frequency control, dispatch control, automatic generation control (AGC), and so on) and are paid accordingly, based on their performance.

I O T -E B RUM LEVEL CONTROL AND ITS NSTALLATION I PLA

a steam turbine thus, generating electricity. Within the boiler drum there exists a steam/water interface. Boiler steam drum water level is one of the important parameters of power plant that must be measured and controlled. For safe and efficient boiler operation, a constant level of water in the boiler drum is required to be maintained.

text