Purchased equipment: what is the use of waste heat boiler
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

what is the use of waste heat boiler
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Overview of Waste Heat Recovery for Power and He

Typical Use: Recover heat from flue gases to heat boiler make-up water • “Regenerators” Typical Use: Recover heat from exhaust to preheat air using thermal mass •“Heat Recovery Steam Generators” (HRSG) Typical Use: Recover heat for steam generation • “Waste Heat Boilers” Typical Use: Recover heat for hot water or steam generation.

WASTE HEAT RECOVERY BOILERS - Johnston Boiler Compa

Following is a typical waste heat recovery application involving operating conditions relating to a Johnston Boiler Company WHR boiler installation. = 187.28 X $3.58/Gal X 5,256 = $3,523,950.00/Year In this example the Johnston Boiler Company waste heat recovery boiler is capable of reducing fuel costs by as much as: $402.00/Hr $9,655.00/Day

What is a Waste Heat Boiler? (with picture) - wisegeek.c

A waste heat boiler uses the heat formed as a byproduct of another process, heat which would normally be wasted, and uses it to create steam. The steam can be used to drive turbines which produce electricity. Alternatively, the boiler can simply be used to heat water or other kinds of fluid.

Waste heat recovery unit - Wikiped

A waste heat recovery unit (WHRU) is an energy recovery heat exchanger that transfers heat from process outputs at high temperature to another part of the process for some purpose, usually increased efficiency.

What is a Waste Heat Boiler? (with picture) - wisegeek.c

A waste heat boiler of the water-tube design is able to cope with much higher pressures of steam than a fire-tube boiler, but it is more difficult to construct and install. Inside this type of boiler, there are narrower tubes than inside a fire-tube boiler, and the tubes contain water instead of hot gases.

Waste heat recovery - Alfa Lav

A key component in waste heat recovery is the heat exchanger. The profitability of an investment in waste heat recovery depends heavily on the efficiency of heat exchangers and their associated life cycle costs (purchase, maintenance, etc). Different designs All these factors vary considerably between different heat exchanger technologies.

Analysis of the use of waste heat obtained from coal-fire

The use of waste heat from boiler exhaust gases for drying brown coal. Drying coal that is being fed into a boiler is a very effective method for improving the efficiency of electricity generation. This is especially important in the case of brown coal because its elemental water content often exceeds 50%.

Waste heat - Wikiped

An example of using STES to utilize natural waste heat is the Drake Landing Solar Community in Alberta, Canada, which, by using a cluster of boreholes in bedrock for interseasonal heat storage, obtains 97 percent of its year-round heat from solar thermal collectors on the garage roofs.

The feasibility of using waste heat boilers to recove

The use of a waste heat boiler would be particularly advantageous either in a melting shop where practical considerations render scrap preheating uneconomic or in tandem with a preheater which removes only a small fraction of the energy in the waste gas stream.

Waste Heat Steam Boiler Used in Glass Industry--Z

We have 600 t/d waste heat recovery boiler that can reuse the waste heat from the processing, make full use of the flue gas heat recovery potential. The effective utilization of waste heat in glass production has become an effective way to reduce the comprehensive energy consumption of glass production.

Industrial Waste-Heat Recovery: Benefits and Recen

The primary sources of waste heat in industrial facilities include exhaust gases from fossil fuel-fired furnaces, boilers, and process heating equipment. These types of high-grade waste-heat sources can readily be used to preheat combustion air, boiler feedwater, and process loads. Waste-heat recovery from lower temperature sources, such

text