Purchased equipment: waste heat recovery boiler auxiliaries
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

waste heat recovery boiler auxiliaries
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Sichuan CRUN Co.,L

Pulverized Coal Fired Boiler Circulating Fluidized Bed Boiler Bagasse(Pulverized Coal Fired) Boiler Cement Kiln Waste Heat Recovery Boiler Glass Kiln Waste Heat Recovery

Industrial Boiler Cost Estimate--Z

Industrial Boiler Cost Estimate the capacity of a boiler, auxiliaries cost, etc. ZBG has have manufactured 9 series 200 types of boilers, including Steam Boiler, Hot Water Boiler, Power Plant Boiler, Fire Tube Boiler, Water Tube Boiler, CFB Boiler, Chain Grate Boiler, Biomass Fired Boiler, Gas & Oil Fired Boiler, and Waste Heat Recovery

WASTE HEAT RECOVERY POWER PLANTS IN CEMENT INDUSTRY - Holt

Waste Heat Recovery Power Plants, contribute significantly, to the electrical energy saving (to the tune of 25%). The reduction in CO 2 emission, makes it environmental friendly. Installation of the waste heat recovery plant has to be tackled as a system approach, rather than considering cement plant and WHRPP operations, independently.

2017.10.10-

Boiler Auxiliaries 、、、、、、、 reduction / waste heat recovery / industrial thermal energy

Boiler and Auxiliaries In Coal Fired Thermal Power Statio

In a boiler it is essential to supply a controlled amount of air to the furnace for effective combustion of fuel and to evacuate hot gases formed in the furnace through the various heat transfer area of the boiler.

PT Atmindo Tbk - Boiler Professionals | Auxiliari

It is a waste heat recovery equipment which uses the waste heat from flue gas to preheat feed water. Economizers can increase boiler efficiency. It is a solution to save fuel, because the higher temperature of incoming feed water reduces the need for additional energy input into the boiler.

HEAT RECOVERY BOILERS - Thermoped

The convective elements of boilers fired by municipal industrial or other waste materials are often referred to as heat recovery boilers although, apart from their geometry, they are more akin to the rear end of a furnace-fired boiler. Perhaps the most common heat recovery boiler is now the gas turbine heat recovery boiler.

Waste Heat Recovery on Merchant Ships - GHG

Other important factors to consider include selecting the right heat exchangers and pumps, and properly calculating pressure losses. One does not select a waste heat recovery exchanger in the same way as a cooler. In the end, the hot water loop recovers heat from main engine as well as that of the auxiliaries.

Waste Heat Recovery Boilers - ThomasN

Custom manufacturer of waste heat recovery systems including waste heat recovery boilers. Fabricated in custom specifications and application requirements. Waste heat recovery boiler systems are designed to reduce energy consumption and used for catalytic cracking, calcining, incineration, hot flue gases, hydrogen and sulfur process applications.

Cheema Boilers Limited : About

Single Drum, Natural Circulation: Bottom/ Top Supported Design; Vertical Self cleaning Design for greater operational comfort. Design takes care of high dust concentration in gases.

Waste Heat Recovery Boilers - Wanda Boil

Waste Heat Recovery Boilers As the leader of application of waste heat recovery, Wanda Boiler has been developing waste heat boilers since 1980s and has achieved many patents and exclusive technology.

text