Purchased equipment: waste heat boiler model data sheet
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

waste heat boiler model data sheet

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Cyclone Waste Heat Engine - Wikiped

The Cyclone Waste Heat Engine (WHE) is a single-acting, Uniflow steam engine. The two main variations are the WHE-25, a six-cylinder radial engine that was under development until November 2013, and the 3-cylinder WHE-DR that has been under development since.

ACBOILERS - Biomass and Waste to Energy Boile

Among our major references, we would like to highlight the boilers installed at Brescia Biomass and Waste-to-Energy Plant in Italy and the Le Gol coal/bagasse fired boiler in La Reunion Island (Indian Ocean).

Chapter 14 - Boiler System Failures | SUEZ Wate

A frequent contributor to waste heat boiler problems is the uneven distribution of gases across the inlet tubes at the hot end. This causes unequal stresses and distortion and leads to mechanical stress and fatigue problems.

Waste Heat-to-Power in Small Scale Industry Using Scrol

Waste Heat-to-Power . in Small Scale Industry Using Scroll Expander for Organic Rankine Bottoming Cycle. Development of an Efficient, Cost-Effective System to Recover Medium-Grade Industrial Waste Heat There is a significant opportunity to . recover waste heat that is exhausted in various manufacturing industries, including food processing.


WASTE HEAT RECOVERY BOILERS Boiler Model Number Gas Side Pressure Drop “ WC Outlet Gas Temperature °F Heat Recovered MBH 100,000 1,200 WHR-132-16 4.5 435 21,369 Waste heat boiler uses heat tracing, external piping and internal coil to prevent freez-ing. All controls were boxed to protect from weather.

Use Feedwater Economizers for Waste Heat Recove

Energ Tips STEA Steam Tip Sheet 3 Use Feedwater Economizers for Waste Heat Recovery A feedwater economizer reduces steam boiler fuel requirements by transferring heat from the flue gas to incoming feedwater. Boiler flue gases are often rejected to the stack at temperatures more than 100°F to 150°F higher than the temperature of the generated

Waste Heat Recovery for the Cement Sect

viii Waste Heat Recovery for the Cement Sector This report analyzes the current status of Waste Heat Recovery (WHR) technology deployment in developing countries and investigates the success factors in countries where WHR has become widely spread.

OSTI.GOV Technical Report: Install Waste Heat Recover

Abstract. Chinese translation of ITP fact sheet about installing Waste Heat Recovery Systems for Fuel-Fired Furnaces. For most fuel-fired heating equipment, a large amount of the heat supplied is wasted as exhaust or flue gases.

Download spreadsheet templates from Rules of Thumb fo

Size a waste heat boiler. 23 – Refrigeration. Data sheets for mechanical refrigeration systems and steam jet refrigeration systems are given. 29 – Physical Properties. This template is highlighted by the VBA functions that calculate water and steam thermodynamic properties.

biogas boiler datasheet in waste gas of fishi

Natural gas, town gas, biogas,diesel, waste oil or waste heat from gas/oil just like a vacuum boiler. Read More Material Safety Data Sheet - UMass AmherstMethane 001033 Synthetic/Analytical chemistry. 2/15/2009.

Waste Heat Boiler Datasheet -- Cleaver-Brooks - GlobalSp

With our many years of custom energy recovery from combustors, industrial processes, and gasification processes, Cleaver-Brooks provides natural circulation designs with membrane wall construction.