Purchased equipment: discribe waste heat boiler
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

discribe waste heat boiler
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Aad Prasadesta | Boiler | Steam - Scribd - Read book

7) Inspect the auxiliary and waste heat boiler installation aboard your vessel and read manufacture’s manual. Describe in detail the construction of the auxiliary and waste heat boilers aboard your vessel. Completly classify the boilers as to the type of boiler, the type of water cuirculation, etc. Include the manufacturer name, capacity and

Chapter 55 - Environmental Pollution Contr

The industries producing major waste heat are fossil fuel (oil, gas and coal) and nuclear power generating plants, steel mills, petroleum refineries, chemical plants, pulp and paper mills, distilleries and laundries.

Design of SRU Thermal Reactor and Waste Heat Boile

The first section of sulphur recovery units (SRU) based on Claus process is constituted of a burner, a thermal reactor and a waste heat boiler and it is designed to oxidize acid gases by air.

Boiler Questions and Answers - Marine steam boile

Question: Cavitation in a two flow line We have a steam genereting facilty using process heat. The condenser is a vertical condenser with process vapours on tube side and boiler feed water on shell side.

Waste Heat Recovery from High-Temperature Blast Furnac

part of the gravity bed boiler and the heat recovery rate can reach as much as 91%. As a consequence, it is possible to recycle thermal energy from high-temperature slag particles using a gravity bed waste heat boiler to produce steam.

CFD Simulation of Flow Distribution in a Waste Heat Boile

To compare different cases of Waste heat boiler with guide vanes attached to the WHB in different angles and different numbers. 3. Specification of working Models Figure 1 shows the base model of the Waste heat boiler, based on the drawing the model is created, meshed and analyzed. Height of duct is 5182 mm and diameter of RA

Economizer - Wikiped

The economizer also prevents flooding of the boiler with liquid water that is too cold to be boiled given the flow rates and design of the boiler. A common application of economizers in steam power plants is to capture the waste heat from boiler stack gases and transfer it to the boiler feedwater. This raises the temperature of the boiler

A Robust SRU Waste Heat Boiler Desi

A Robust SRU Waste Heat Boiler Design 2012 Brimstone Sulfur Symposium Facilitated by Brimstone STS Limited Page 3 of 21 • Sept. 2003: Second planned turnaround. Installed new single-pass WHB. • Oct. 2006: Out-of-cycle shutdown due to hot spots on reaction furnace caused by refractory failure.

blown gas waste heat boiler fuel - kodim0604-karawang.c

The excess air coefficient at the boiler tail is less than 1.2, which not only reduces the heat loss of the exhaust smoke and power consumption of the induced draft fan, but also greatly reduces the environmental pollution of the boiler house.

How to recycle or dispose of common waste item

How to recycle or dispose of common waste items. A range of items can be recycled or disposed of at our recycling centres including glass, paper and cardboard, plastic bottles, textiles, metals, electricals, engine oil, car batteries, cooking oil and green waste.

What is thermal insulation and how is it used? - Quo

Thermal insulation is the reduction of heat transfer between objects in thermal contact or in range of radiative that will be influencing transfers thermal energy between objects by differing the temperature.

text