Purchased equipment: boiler flue gas waste heat recovery technology
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

boiler flue gas waste heat recovery technology
Others

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Heat recovery FAQ - Thermal Energy Internation

FLU-ACE uses direct contact gas-to-liquid mass transfer and heat exchange. It condenses almost all of the water vapour (steam) from the exhaust, and this latent heat is the source of the bulk of the waste heat available in a boiler flue gas. “Sensible” heat refers to energy that can be released through a temperature change.

WASTE HEAT RECOVERY TECHNOLOGIES FROM HEATING BOILER FLUE G

Recovery of heat contained in the flue gas leads to the increase of thermal efficiency and thus to the decrease of boiler fuel consumption and pollutant emissions. To recover as much as possible of the waste heat, exhaust gas must be cooled deeper to recover both sensible heat of the flue gas and latent heat of water vapour from flue gas.

China Boiler Flue Gas Waste Heat Recovery Exchange

Waste Heat Recovery, Heat Recovery Exchanger, Flue Gas Heat Exchanger manufacturer / supplier in China, offering Boiler Flue Gas Waste Heat Recovery Exchanger, Water Saving HVAC Cooling Tower, Energy Saving Industrial Cooling Tower and so on.

Coal power plant flue gas waste heat and water recover

An advanced waste heat and water recovery technology has been developed to extract a portion of the water vapor and its latent heat from flue gases based on a nanoporous ceramic membrane capillary condensation separation mechanism.

Heat exchangers for energy recovery in waste and biomas

Energy recovery system of waste-to-energy and/or biomass to energy units represents a substantial part of the whole technology which enables to utilize heat contained in flue gas (off-gas) from incinerators or combustion chambers as much as possible.

Waste Heat Recovery | Flue Gas Cooling | GE Pow

Controlled Flue Gas Cooling & Waste Heat Exchanger Solutions. GE’s waste heat recovery plant solutions aren’t just a way to cut costs and lower emissions, they allow you to recover more energy than you ever thought possible—contributing to a more successful, profitable plant.

Use Feedwater Economizers for Waste Heat Recove

heat from the flue gas to incoming feedwater. Boiler flue gases are often rejected to the stack at temperatures more than 100°F to 150°F higher than the temperature of the generated steam. Generally, boiler efficiency can be increased by 1% for every 40°F reduction in flue gas temperature. By recovering waste heat, an economizer can often

Waste heat recovery boiler -- ZBG Boil

During the operation of the waste heat boiler, the high-temperature flue gas with a large amount of heat enters the furnace first, then enters the waste heat recovery device of the front smoke box, then enters the pyrotechnic tube, and finally enters the waste heat recovery device in the rear smoke box flue, and the high-temperature flue gas

China Boiler Flue Gas Waste Heat Recovery Exchange

Waste Heat Recovery, Heat Recovery Exchanger, Flue Gas Heat Exchanger manufacturer / supplier in China, offering Boiler Flue Gas Waste Heat Recovery Exchanger, Water Saving HVAC Cooling Tower, Energy Saving Industrial Cooling Tower and so on.

The recovery of waste heat of flue gas from gas boiler

A conventional system means that the heat is supplied by the natural gas boiler without the flue gas waste heat recovery. (34) where Y is the payback year of the increased investment, Δ C is the initial investment increment compared with the conventional system, and Δ R is the increased profit compared with the conventional system.

DRAFT PRE-DECISIONAL DRAFT Waste Heat Recovery Technolog

DRAFT – PRE-DECISIONAL – DRAFT 2 23 1. Introduction to the Technology/System 24 1.1. Introduction to Waste Heat Recovery 25 Waste heat in manufacturing is generated from several industrial systems distributed throughout 26 a plant. The largest sources of waste heat for most industries are exhaust and flue gases and

text