Purchased equipment: boiler super heater tubes
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

boiler super heater tubes

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Technical advantages

Digitized manufacture

  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.
  • The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Long life span

  • The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life;
  • Convection section: optimize convection heating surface and adopt effective fix and structural support to make its working life longer.
  • Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Less fuel consumption

  • Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.
  • Furnace adopts double close line coil, which makes heating surface sufficient.

Add Comment

Superheater Tube From Boiler - Metallurgical Technologie

Metallurgical Technologies, Inc. examined a failed superheater tube from XXXXXX X XXX Boiler #7. The ASME SA-213 Grade T11 tube had been in service for 6 to 8 years until failure. The mode of failure was short-term stress rupture due to significant overheating.

Failure Analysis And Optimization Of Reheater And Supe

tubes located in the boiler. Super heater tubes directly passes the steam produced in the high pressure turbine.Steam from the water wall passes to the super heaters where it is heated above its saturation temperature until the maximum required operating temperature is achieved..Super heater increases the efficiency of the boiler.

Superheater, Superheater Suppliers and Manufacturers a

Delivery Detail: 30days Specifications BS3059 steel boiler tube 1.OD10~114mm 2WT0.8~15mm 3.Certificated by TUV,SGS,BV 4.Used for boiler and superheater BS3059 steel boiler and superheater tubes We are the seamless steel pipes manufacturer, we supply pipes with high quality.

Superheater tubes for boilers — Sandvik Materials Technolo

Superheater tubes and reheater tubes in a comprehensive range of stainless steels and nickel alloys for a wide range of boiler applications.

International Research Journal of Engineering an

power plant is mostly due to failure in the Boiler tubes of different zones such as Super heater and Re-heater tubes. Failure of tubes in boiler of the power plants may occur due to various reasons. These failure were mainly in the first row of the primary super heater tubes, therefore,

superheater tubes | Sunny Steel Enterprise Lt

Steel tubes for Superheater to protect from warping and burning out. A superheater is a device used to convert saturated steam or wet steam into dry steam used in steam engines or in processes, such as steam reforming. There are three types of superheaters namely: radiant, convection, and separately fired.

Boiler, boiler parts,economizer,superheater - ORL Pow

ORL Power is a leading company and exporter of industrial boilers, power plant boilers and boiler parts (including steam drum, membrane waterwall panel, header, economizer, evaporator, super heater, H-fin economizer, spiral fin tube, air preheater, heat pipe, flue etc.), and seamless steel tubes/pipes.

ASTM Standard for Boilers tube, Super heater tubes | Sunn

Share ASTM A192 Specification for Seamless Carbon Steel Boiler Tubes for High-Pressure Service Abbr. Corresponding Application A178 A178/A178M-95 Specification for Electric-Re ASTM Standard for Boilers tube, Super heater tubes. Posted on 13 November, 2012 by sunnysteel. Share. ASTM A192 Specification for Seamless Carbon Steel Boiler Tubes

CHANGBAO-HRSG super long boiler tubes - Jiangsu Chan

HRSG SUPER LONG TUBES LENGTH: 16-26M (MAX L = 28M) Standard (part ): GB5310-2008 Seamless steel tube for high pressure boiler ASME SA210 Seamless

Failure investigation of super heater tubes of coal fire

Failure of super heater tube of boiler is the major concern of forced outages at coal fired thermal power plant. Flue gas passes over super heater tubes leading to damage over the time of operation and termed as fireside damage/corrosion.

Superheater - Manufacturers, Suppliers & Exporters in Ind

Super heater super heats the saturated steam coming from Steam drum to reduce the moisture content of steam. The super heater tubes are supported by baffles plates. Super heater is equipped with nozzles for steam inlet outlet, HTF inlet outlet, drain, vent, pressure and level gauges, saddle, lifting hook arrangements etc.